v2.6.3

BMS_Main_X2_v2.6.3.srec 

Improvements

• adaptation of the device to the production test bench

v2.6.2

BMS_Main_X2_v2.6.2.srec 

Fixes

• resolving the problem of saving device parameters

v2.6.1

BMS_Main_X2_v2.6.1.srec 

Fixes

• resolving the issue of preparing battery module states written to Modbus registers
• resolving the problem of writing the device's working time to a non-volatile memory very often
• resolving the problem of returning error states when saving device parameters (mainly via Wi-Fi)

v2.6.0

BMS_Main_X2_v2.6.0.srec 

Features

• new parameter to set the minimum number of battery modules allowed to join (see the "Control - Charge" and "Control - Discharge" sections)
• ability to rejoin battery modules if their voltage is close to the battery voltage (see the "Control - Charge" and "Control - Discharge" sections)
• selection of errors that cause reset of contactor control signals (see the "Control - Main contactor", "Control - Charge", "Control - Discharge", "Control - Heater", "Control - Cooler" sections)
• new internal signal "General error (modules)" which is the logical sum of the "General error" signals from the battery modules
• new assignments "Charging", "Precharging", "Discharging", "Charging/Discharging", "Main contactor", "Critical error" and "General error (modules)" for the discrete outputs (see the "Signals - Output discrete signals - Assignments" section)
• new assignments "Critical error" and "General error (modules)" for the relays (see the  "Signals - Relays - Assignments" section)

Improvements

• rearrangements in the settings sections, which are made to simplify the setup process

Fixes

• resolving the problem of device hanging due to high activity on the CAN bus during startup