Wiki source code of BMS Main X
Hide last authors
| author | version | line-number | content |
|---|---|---|---|
 |
3.1 | 1 | = v2.6.2 = |
| 2 | |||
| 3 | [[BMS_Main_X2_v2.6.2.srec>>FileManager.BMS_Main_X2_v2\.6\.2\.srec]] | ||
| 4 | |||
| 5 | == Fixes == | ||
| 6 | |||
| 7 | * resolving the problem of saving device parameters | ||
| 8 | |||
| 9 | = v2.6.1 = | ||
| 10 | |||
| 11 | [[BMS_Main_X2_v2.6.1.srec>>FileManager.BMS_Main_X2_v2\.6\.1\.srec]] | ||
| 12 | |||
| 13 | == Fixes == | ||
| 14 | |||
| 15 | * resolving the issue of preparing battery module states written to Modbus registers | ||
| 16 | * resolving the problem of writing the device's working time to a non-volatile memory very often | ||
| 17 | * resolving the problem of returning error states when saving device parameters (mainly via Wi-Fi) | ||
| 18 | |||
| |
1.2 | 19 | = v2.6.0 = |
| 20 | |||
| 21 | [[BMS_Main_X2_v2.6.0.srec>>FileManager.BMS_Main_X2_v2\.6\.0\.srec]] | ||
| 22 | |||
| 23 | == Features == | ||
| 24 | |||
| 25 | * new parameter to set the minimum number of battery modules allowed to join (see the "Control - Charge" and "Control - Discharge" sections) | ||
| 26 | * ability to rejoin battery modules if their voltage is close to the battery voltage (see the "Control - Charge" and "Control - Discharge" sections) | ||
| 27 | * selection of errors that cause reset of contactor control signals (see the "Control - Main contactor", "Control - Charge", "Control - Discharge", "Control - Heater", "Control - Cooler" sections) | ||
| 28 | * new internal signal "General error (modules)" which is the logical sum of the "General error" signals from the battery modules | ||
| 29 | * new assignments "Charging", "Precharging", "Discharging", "Charging/Discharging", "Main contactor", "Critical error" and "General error (modules)" for the discrete outputs (see the "Signals - Output discrete signals - Assignments" section) | ||
| 30 | * new assignments "Critical error" and "General error (modules)" for the relays (see the "Signals - Relays - Assignments" section) | ||
| 31 | |||
| |
2.1 | 32 | == Improvements == |
| |
1.2 | 33 | |
| |
2.1 | 34 | * rearrangements in the settings sections, which are made to simplify the setup process |
| 35 | |||
| 36 | == Fixes == | ||
| 37 | |||
| 38 | * resolving the problem of device hanging due to high activity on the CAN bus during startup |