new parameter to set the minimum number of battery modules allowed to join (see the "Control - Charge" and "Control - Discharge" sections)
ability to rejoin battery modules if their voltage is close to the battery voltage (see the "Control - Charge" and "Control - Discharge" sections)
selection of errors that cause reset of contactor control signals (see the "Control - Main contactor", "Control - Charge", "Control - Discharge", "Control - Heater", "Control - Cooler" sections)
new internal signal "General error (modules)" which is the logical sum of the "General error" signals from the battery modules
new assignments "Charging", "Precharging", "Discharging", "Charging/Discharging", "Main contactor", "Critical error" and "General error (modules)" for the discrete outputs (see the "Signals - Output discrete signals - Assignments" section)
new assignments "Critical error" and "General error (modules)" for the relays (see the "Signals - Relays - Assignments" section)
Improvements
rearrangements in the settings sections, which are made to simplify the setup process
Fixes
resolving the problem of device hanging due to high activity on the CAN bus during startup
