Skip to Content

Changes for page BMS Main X

Last modified by Admin on 2025/02/19 08:28
From version 3.1
edited by Admin
on 2024/11/22 09:01
Change comment: There is no comment for this version
To version 1.1
edited by Admin
on 2024/11/22 08:56
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,38 +1,0 @@
1 -= v2.6.2 =
2 -
3 -[[BMS_Main_X2_v2.6.2.srec>>FileManager.BMS_Main_X2_v2\.6\.2\.srec]]
4 -
5 -== Fixes ==
6 -
7 -* resolving the problem of saving device parameters
8 -
9 -= v2.6.1 =
10 -
11 -[[BMS_Main_X2_v2.6.1.srec>>FileManager.BMS_Main_X2_v2\.6\.1\.srec]]
12 -
13 -== Fixes ==
14 -
15 -* resolving the issue of preparing battery module states written to Modbus registers
16 -* resolving the problem of writing the device's working time to a non-volatile memory very often
17 -* resolving the problem of returning error states when saving device parameters (mainly via Wi-Fi)
18 -
19 -= v2.6.0 =
20 -
21 -[[BMS_Main_X2_v2.6.0.srec>>FileManager.BMS_Main_X2_v2\.6\.0\.srec]]
22 -
23 -== Features ==
24 -
25 -* new parameter to set the minimum number of battery modules allowed to join (see the "Control - Charge" and "Control - Discharge" sections)
26 -* ability to rejoin battery modules if their voltage is close to the battery voltage (see the "Control - Charge" and "Control - Discharge" sections)
27 -* selection of errors that cause reset of contactor control signals (see the "Control - Main contactor", "Control - Charge", "Control - Discharge", "Control - Heater", "Control - Cooler" sections)
28 -* new internal signal "General error (modules)" which is the logical sum of the "General error" signals from the battery modules
29 -* new assignments "Charging", "Precharging", "Discharging", "Charging/Discharging", "Main contactor", "Critical error" and "General error (modules)" for the discrete outputs (see the "Signals - Output discrete signals - Assignments" section)
30 -* new assignments "Critical error" and "General error (modules)" for the relays (see the "Signals - Relays - Assignments" section)
31 -
32 -== Improvements ==
33 -
34 -* rearrangements in the settings sections, which are made to simplify the setup process
35 -
36 -== Fixes ==
37 -
38 -* resolving the problem of device hanging due to high activity on the CAN bus during startup