Changes for page 3.3 Control

Last modified by Admin on 2025/04/09 12:15

From version 4.1

edited by Admin
on 2025/01/28 15:19

Change comment: There is no comment for this version

To version 3.1

edited by Admin
on 2024/12/11 13:18

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -273,10 +273,7 @@
  * Voltage to reset the “Ready to charge” – a tolerant voltage level on the cell, V; if all cell voltages are below the tolerant level, the “Ready to charge” (hence, the “Allow charging”) signal is set;
  * Delay before recharging – a time after which the previously opened the allow charging contactor closes again, minute; to disable the operation by timeout set "Delay before recharging" to 0.
--(% class="box infomessage" %)
--(((
  Note – The allow charging contactor closes under two independent conditions: 1) the voltage on the cells reaches the “Voltage to reset the “Ready to charge"” level and 2) the "Delay before recharging" time has passed since the opening of the allow charging contactor.
--)))
  === Discharge ===