Skip to Content

Changes for page 3.3 Control

Last modified by Admin on 2025/04/09 12:15
From version 31.1
edited by Admin
on 2025/02/24 13:52
Change comment: Загрузить новое вложение 1740405145695-704.png
To version 32.1
edited by Admin
on 2025/02/24 13:54
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -618,7 +618,7 @@
618 618  * Tolerant cell temperature, °C;
619 619  * Delay before starting the heater, millisecond;
620 620  * Delay before stopping the heater, millisecond;
621 -* Errors 1, 2 to turn off the heater – bitfields to choose the errors which will turn off the heater;
621 +* Errors 1, 2 to turn off the heater – bitfields to choose the errors which will turn off the heater.
622 622  
623 623  As a result of operating the heating algorithm, the “Heater” signal is generated.
624 624  
... ... @@ -639,8 +639,8 @@
639 639  
640 640  To change the parameters of the cooler control algorithm, select the "Control → Cooler" section:
641 641  
642 -[[image:1733746808497-424.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="113" width="800"]]
643 643  
643 +[[image:1740405145695-704.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="149" width="800"]]
644 644  In this section:
645 645  
646 646  * Enable – a flag to enable cooler control;
... ... @@ -648,7 +648,7 @@
648 648  * Tolerant cell temperature, °C;
649 649  * Delay before starting the cooler, millisecond;
650 650  * Delay before stopping the cooler, millisecond;
651 -* Switch off the cooler contactor on errors (Undervoltage, Overcurrent, Low temperature, Short circuit or Critical error).
651 +* Errors 1, 2 to turn off the heater – bitfields to choose the errors which will turn off the cooler.
652 652  
653 653  As a result of operating the cooling algorithm, the "Cooler" signal is generated.
654 654