Skip to Content
Last modified by Admin on 2025/03/18 12:50
From version 4.1
edited by Admin
on 2025/01/28 13:55
Change comment: There is no comment for this version
To version 3.4
edited by Admin
on 2024/12/11 13:11
Change comment: Update document after refactoring.

Summary

Details

Page properties
Content
... ... @@ -16,8 +16,12 @@
16 16  
17 17  [[image:1733740731820-300.png||data-xwiki-image-style-alignment="center" height="172" width="453"]]
18 18  
19 -|**Parameter**|**Value **
20 -|Overall dimensions (length × width × height), mm|124.5 × 117 × 17
19 +|(((
20 +**Parameter**
21 +)))|**Value **
22 +|(((
23 +Overall dimensions (length × width × height), mm
24 +)))|124.5 × 117 × 17
21 21  |Mounting dimensions (length × width), mm|115 × 111
22 22  |Mounting holes|M3
23 23  
... ... @@ -55,12 +55,13 @@
55 55  (((
56 56  **ATTENTION!!!**
57 57  The load should be connected to +12V and OUTx pins. The feedback signal should be connected to FBx and GND pins. Below is an example of connecting the BMS to a contactor:
58 -[[image:1733738760833-185.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true"]]
59 59  )))
60 60  
64 +[[image:1733738760833-185.png||data-xwiki-image-style-alignment="center"]]
65 +
61 61  === X2 – mini-USB connector. ===
62 62  
63 -Mini-USB connector is used for configuring the BMS via ElectricDeviceMonitor.
68 +Mini0USB connector is used for configuring the BMS via ElectricDeviceMonito
64 64  
65 65  === X3 – header for discrete inputs and outputs signals.[[image:1733738860923-996.png||data-xwiki-image-style-alignment="center" height="90" width="283"]] ===
66 66  
... ... @@ -175,6 +175,7 @@
175 175  
176 176  === Connecting battery cells ===
177 177  
183 +
178 178  To connect battery cells, follow figure below. Incorrect connection of the cells can damage the BMS Mini.
179 179  
180 180  Begin the connection with the negative line of the battery: the “C0“ is connected to the “B-“, then the first cell (C1) is connected, then the second (С2), etc. If not all inputs of the cells are used, then the remaining inputs are connected to the cell with the most potential.