Changes for page 3.5 External equipment

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -76,7 +76,7 @@
76	76
77	77	To change communication parameters with vehicle with Unibat battery installed, select the "External equipment → Unibat vehicle" section:
78	78
79		-[[image:1739970298499-463.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="302" width="600"]]
	79	+[[image:1748623056947-344.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="347" width="600"]]
80	80
81	81	In this section:
82	82
...	...	@@ -87,7 +87,9 @@
87	87	* Use CRC – a flag to enable checking the checksum of the control message;
88	88	* Use DTC – a flag to enable transmit of error codes on battery failures;
89	89	* Use additional current sensors to determine error – a flag to use measuring of second and third current sensor to determine errors in battery work;
	90	+* Use continuous charge current limit – a flag to use continuous charge current limit;
90	90	* Invert discharge current limit;
	92	+* Disable insulation measurement;
91	91	* Number of modules – total number of battery modules;
92	92	* Receive timeout – a timeout for receiving packets from the vehicle (if there is no messages during that time, an error generates), millisecond;
93	93	* HVIL delay – a delay before generating a signal of high-voltage interrupt loop breakage, millisecond;
...	...	@@ -104,6 +104,7 @@
104	104	* Nominal capacity – nominal battery capacity, Wh;
105	105	* Current threshold for contactor opening – a current value for safe contactor opening, A;
106	106	* Waiting time until the current drops below the threshold – a waiting time for current to drop below estimated value before safe contactor opening, millisecond;
	109	+* Bus
107	107	* Control ventilation fans – a flag to send command messages to control battery ventilation fans;
108	108	* Version: Manufacturer;
109	109	* Version: Hardware ID;