Skip to Content

Changes for page 3.5 External equipment

Last modified by Admin on 2025/05/30 16:50
From version 13.1
edited by Admin
on 2025/03/03 10:08
Change comment: There is no comment for this version
To version 10.2
edited by Admin
on 2025/02/19 13:06
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -82,12 +82,9 @@
82 82  
83 83  * Enable – a flag to enable communication with the vehicle;
84 84  * CAN port – port which is used to communicate with the vehicle;
85 -* BMS address;
86 -* VCU address;
87 87  * Use CRC – a flag to enable checking the checksum of the control message;
88 88  * Use DTC – a flag to enable transmit of error codes on battery failures;
89 89  * Use additional current sensors to determine error – a flag to use measuring of second and third current sensor to determine errors in battery work;
90 -* Invert discharge current limit;
91 91  * Number of modules – total number of battery modules;
92 92  * Receive timeout – a timeout for receiving packets from the vehicle (if there is no messages during that time, an error generates), millisecond;
93 93  * HVIL delay – a delay before generating a signal of high-voltage interrupt loop breakage, millisecond;
... ... @@ -108,7 +108,7 @@
108 108  * Version: Manufacturer;
109 109  * Version: Hardware ID;
110 110  * Version: Software ID;
111 -* Version: Configuration;
108 +* Version: Confoguration;
112 112  * Version: Serial Number;
113 113  * Version: Production date;
114 114  * Errors 1, 2 for emergency shutdown – a bitfield with errors to emergency shutdown the vehicle.
... ... @@ -127,6 +127,7 @@
127 127  * Receive timeout – a timeout for receiving packets from the charger (if there is no data being received from the charger for a given time, the connection loss flag is set), millisecond;
128 128  * Output period - a period of sending commands to the charger, millisecond;
129 129  * Charging voltage – maximum charging voltage, V;
127 +* Charging current – maximum charging current, A;
130 130  * Set “Charger connected” signal if the charger is online – a flag to generate the “Charger connected” signal if connection with the charger is established.
131 131  
132 132  (% class="box infomessage" %)