Skip to Content

Changes for page 3.5 External equipment

Last modified by Admin on 2025/05/30 16:50
From version 10.1
edited by Admin
on 2025/02/19 13:04
Change comment: Uploaded new attachment "1739970298499-463.png", version {1}
To version 11.1
edited by Admin
on 2025/02/19 13:07
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -72,17 +72,22 @@
72 72  * Alarm threshold – a threshold resistance value to set insulation alarm, Ohm;
73 73  * Warning threshold – a threshold resistance value to set insulation warning, Ohm.
74 74  
75 -=== Unibat vehicle ===
75 +=== Unibat vehicle ===
76 76  
77 77  To change communication parameters with vehicle with Unibat battery installed, select the "External equipment → Unibat vehicle" section:
78 78  
79 -[[image:1739294567774-840.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="290" width="600"]]In this section:
79 +[[image:1739970298499-463.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="302" width="600"]]
80 80  
81 +In this section:
82 +
81 81  * Enable – a flag to enable communication with the vehicle;
82 82  * CAN port – port which is used to communicate with the vehicle;
85 +* BMS address;
86 +* VCU address;
83 83  * Use CRC – a flag to enable checking the checksum of the control message;
84 84  * Use DTC – a flag to enable transmit of error codes on battery failures;
85 85  * Use additional current sensors to determine error – a flag to use measuring of second and third current sensor to determine errors in battery work;
90 +* Invert discharge current limit;
86 86  * Number of modules – total number of battery modules;
87 87  * Receive timeout – a timeout for receiving packets from the vehicle (if there is no messages during that time, an error generates), millisecond;
88 88  * HVIL delay – a delay before generating a signal of high-voltage interrupt loop breakage, millisecond;