Skip to Content

Changes for page 3.4 Protections

Last modified by Admin on 2025/04/09 12:19
From version 6.2
edited by Admin
on 2024/12/25 11:57
Change comment: There is no comment for this version
To version 8.3
edited by Admin
on 2024/12/26 14:44
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -44,9 +44,11 @@
44 44  
45 45  === Charge current limit ===
46 46  
47 +TBA
47 47  
48 48  === Discharge current limit ===
49 49  
51 +TBA
50 50  
51 51  === Undervoltage ===
52 52  
... ... @@ -54,7 +54,7 @@
54 54  
55 55  To change the battery protection parameters from low voltage on the cells, select the "Protections → Undervoltage" section:
56 56  
57 -[[image:1733328382380-760.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="127" width="800"]]
59 +[[image:1735224224155-829.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="112" width="800"]]
58 58  
59 59  In this section:
60 60  
... ... @@ -61,6 +61,7 @@
61 61  * Enable – a flag to enable the protection;
62 62  * Minimum cell voltage, V;
63 63  * Tolerant cell voltage, V;
66 +* Check the open circuit voltage instead of the actual voltage a flag to enable the protection;;
64 64  * Delay before setting the error, millisecond;
65 65  * Delay before clearing the error, second;
66 66  * Lock – a flag to block the error until the device is restarted.
... ... @@ -275,7 +275,7 @@
275 275  If there is the “Water” error, the **“Critical error”** is generated and **all relays open**.
276 276  )))
277 277  
278 -=== High Logic temperature ===
281 +=== Logic high temperature ===
279 279  
280 280  To change the overheating protection parameters of BMS Logic devices, select the "Protections → High Logic temperature" section:
281 281  
... ... @@ -509,6 +509,10 @@
509 509  If there is the "Power switch error", the **“Critical error” **is generated and **all relays open.**
510 510  )))
511 511  
515 +=== Power fault ===
516 +
517 +TBA
518 +
512 512  === Charge contactor cycles ===
513 513  
514 514  The BMS Main 3 device protects the charging contactor against frequent switching.
1735224224155-829.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.admin
Size
... ... @@ -1,0 +1,1 @@
1 +23.4 KB
Content