Skip to Content

Changes for page 3.4 Protections

Last modified by Admin on 2025/04/09 12:19
From version 6.1
edited by Admin
on 2024/12/24 18:36
Change comment: There is no comment for this version
To version 6.4
edited by Admin
on 2024/12/26 12:12
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -42,6 +42,14 @@
42 42  If there is the "Overcurrent" error, the **charging **and **discharging **contactors open.
43 43  )))
44 44  
45 +=== Charge current limit ===
46 +
47 +TBA
48 +
49 +=== Discharge current limit ===
50 +
51 +TBA
52 +
45 45  === Undervoltage ===
46 46  
47 47  The BMS Main 3 device implements battery protection from too low voltage on the cells.
... ... @@ -269,7 +269,7 @@
269 269  If there is the “Water” error, the **“Critical error”** is generated and **all relays open**.
270 270  )))
271 271  
272 -=== High Logic temperature ===
280 +=== Logic high temperature ===
273 273  
274 274  To change the overheating protection parameters of BMS Logic devices, select the "Protections → High Logic temperature" section:
275 275  
... ... @@ -503,6 +503,10 @@
503 503  If there is the "Power switch error", the **“Critical error” **is generated and **all relays open.**
504 504  )))
505 505  
514 +=== Power fault ===
515 +
516 +TBA
517 +
506 506  === Charge contactor cycles ===
507 507  
508 508  The BMS Main 3 device protects the charging contactor against frequent switching.