Skip to Content

Changes for page 3.4 Protections

Last modified by Admin on 2025/04/09 12:19
From version 29.1
edited by Admin
on 2025/04/09 12:19
Change comment: There is no comment for this version
To version 27.2
edited by Admin
on 2025/02/26 12:01
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -94,7 +94,7 @@
94 94  * Enable – a flag to enable the protection;
95 95  * Minimum cell voltage, V;
96 96  * Tolerant cell voltage, V;
97 -* Check the open circuit voltage instead of the actual voltage – a flag to use the U,,ocv,, (corrected due to current and cell resistance) cell voltage;
97 +* Check the open circuit voltage instead of the actual voltage – a flag to enable the check of voltage correction due to current and cell resistance;
98 98  * Delay before setting the error, millisecond;
99 99  * Delay before clearing the error, second;
100 100  * Lock – a flag to block the error until the device is restarted.
... ... @@ -122,7 +122,7 @@
122 122  * Enable – a flag to enable the protection;
123 123  * Maximum cell voltage, V;
124 124  * Tolerant cell voltage, V;
125 -* Check the open circuit voltage instead of the actual voltage – a flag to use the U,,ocv,, (corrected due to current and cell resistance) cell voltage;
125 +* Check the open circuit voltage instead of the actual voltage – a flag to enable the check of voltage correction due to current and cell resistance;
126 126  * Delay before setting the error, millisecond;
127 127  * Delay before clearing the error, second;
128 128  * Lock – a flag to block the error until the device is restarted.
... ... @@ -778,7 +778,7 @@
778 778  * Delay before clearing the error, second;
779 779  * Lock – a flag to block the error until the device is restarted.
780 780  
781 -The "Critical error" signal is generated if at least one of the critical errors (see [[Errors>>doc:Battery management systems.Additional information.1\. Battery controllers\: signals and errors.WebHome||anchor="HErrors"]]) is generated during the “Delay before setting the error” time.
781 +The "Critical error" signal is generated if at least one of the critical errors (see [[Errors>>doc:Battery management systems.Additional information.1\. Battery controllers\: signals and errors.WebHome||anchor="HErrors"]]) is generated during the “Delay before setting the error” time:
782 782  
783 783  The “Critical error" signal is cleared if there are no errors from the list above during the “Delay before clearing the error” time.
784 784  
... ... @@ -796,7 +796,7 @@
796 796  * Lock – a flag to block the error until the device is restarted;
797 797  * Errors 1, 2 to set the "Critical error" – bitfields to enable check of corresponding errors.
798 798  
799 -The “General error”is generated if at least one of the enabled errors is generated during the “Delay before setting the error” time.
799 +The general error flag is generated if at least one of the enabled errors is generated during the “Delay before setting the error” time.
800 800  
801 801  The “General error” is cleared if there are no errors from the enabled errors during the “Delay before clearing the error” time.
802 802