Skip to Content

Changes for page 3.4 Protections

Last modified by Admin on 2025/04/09 12:19
From version 16.19
edited by Admin
on 2024/12/26 15:06
Change comment: There is no comment for this version
To version 14.2
edited by Admin
on 2024/12/26 14:56
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -44,22 +44,8 @@
44 44  
45 45  === Charge current limit ===
46 46  
47 -The BMS Main 3 device can check if the charging current exceeds the estimated limit based on the [[Charge map>>doc:Battery management systems.BMS Main 3.3\. Configuration.3\.3 Control.WebHome||anchor="HChargemap"]].
47 +TBA
48 48  
49 -Current
50 -
51 -If current is more than calculated maximum, "Current limit" error is generated.
52 -
53 -
54 -To change the overcurrent protection of the battery, select the "Protections → Charge current limit" section:
55 -
56 -[[image:1735225207687-430.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="113" width="800"]]In this section:
57 -
58 -* Enable – a flag to enable the protection;
59 -* Threshold to switch from Region 1 to Region 2
60 -*
61 -
62 -
63 63  === Discharge current limit ===
64 64  
65 65  TBA
... ... @@ -822,7 +822,7 @@
822 822  * Delay before setting the error, millisecond;
823 823  * Delay before clearing the error, second;
824 824  * Lock – a flag to block the error until the device is restarted;
825 -* Errors 1, 2 to set the "Critical error" – bitfields to enable check of corresponding errors.
811 +* Errors 1, 2 to ser – a flags to enable check of corresponding errors.
826 826  
827 827  The general error flag is generated if at least one of the enabled errors is generated during the “Delay before setting the error” time.
828 828  
1735225207687-430.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.admin
Size
... ... @@ -1,1 +1,0 @@
1 -23.0 KB
Content