Skip to Content

Changes for page 3.4 Protections

Last modified by Admin on 2025/04/09 12:19
From version 16.15
edited by Admin
on 2024/12/26 15:05
Change comment: There is no comment for this version
To version 14.3
edited by Admin
on 2024/12/26 14:56
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -44,18 +44,8 @@
44 44  
45 45  === Charge current limit ===
46 46  
47 -The BMS Main 3 device can check if the charging current exceeds the limit based on the Charge map. If current is more than estimated maximum, "Current limit" error is generated.
47 +TBA
48 48  
49 -
50 -To change the overcurrent protection of the battery, select the "Protections → Charge current limit" section:
51 -
52 -[[image:1735225207687-430.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="113" width="800"]]In this section:
53 -
54 -* Enable – a flag to enable the protection;
55 -* Threshold to switch from Region 1 to Region 2
56 -*
57 -
58 -
59 59  === Discharge current limit ===
60 60  
61 61  TBA
... ... @@ -818,7 +818,7 @@
818 818  * Delay before setting the error, millisecond;
819 819  * Delay before clearing the error, second;
820 820  * Lock – a flag to block the error until the device is restarted;
821 -* Errors 1, 2 to set the "Critical error" – bitfields to enable check of corresponding errors.
811 +* Errors 1, 2 to set the  – a flags to enable check of corresponding errors.
822 822  
823 823  The general error flag is generated if at least one of the enabled errors is generated during the “Delay before setting the error” time.
824 824  
1735225207687-430.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.admin
Size
... ... @@ -1,1 +1,0 @@
1 -23.0 KB
Content