Перейти к содержимому

3.1 General information

Редактировал(а) Admin 2025/02/12 12:35

Configuration

General information

This document describes how to configure the BMS Main 3 device.

Настройка осуществляется с помощью программы ElectricDeviceMonitor версии не ниже 1.18.0 (доступна по ссылке) по

  • USB;
  • CAN bus (поддерживаются адаптеры Systec, PEAK, Marathon и USB-CAN);
  • TCP connection (для этого должны быть установлены BMS Wi-Fi или BMS LANmodule).

After connecting device to the PC, launch ElectricDeviceMonitor, select "Unified monitor" in the main program window:

1735233230234-960.png

Choose the connection type and set up connection settings:

  • Serial port (USB): choose the corresponding COM port;

1733320484262-545.png1733320484267-118.png

  • Systec USB-CAN, PEAK USB-CAN, Marathon USB-CAN, BMS USB-CAN: select the device in device list, specify the CAN speed and BMS device address:

1735233434987-983.png

  • TCP connection: set up the device IP address.

1735234302538-838.png

When connected, the device asks for an access password.

Below is the list of available users. Default passwords can be changed in "Device -> Change password" menu. 

UserDefault PasswordDescription
GuestguestGuest access to view battery state. No permissions to change and view any settings
UseruserA common user access with permissions to change almost all the settings
ServiceserviceA service account for battery manufacturers. Has access to some additional settings
Manufacturer-This account is used by BMS manufacturer and not accessible for others

1735053821120-339.png

After successful authentication, the device will send settings and state profiles, which will be displayed as two tabs: "Settings" and "State":

1735053858994-348.png

The monitor window is divided into three areas. The upper area displays controls for starting and stopping communication with the device, information about the device (its name, hardware and firmware versions, time on the device clock), and controls for performing actions with the device (change password, restart, reset, etc.).

The central area displays the parameters and state variables of the device. The tabs in this area are divided into three columns. The first column displays parameter groups in a tree form, the second column displays records for the selected group, and the third displays the detailed description of the record.

The lower area shows the history of device activity.