Skip to Content

Changes for page BMS Mini S / BMS Mini

Last modified by Admin on 2025/04/14 10:53
From version 7.1
edited by Admin
on 2024/12/17 12:52
Change comment: There is no comment for this version
To version 6.2
edited by Admin
on 2024/12/17 12:52
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,12 +1,14 @@
1 1  (% class="wikigeneratedid" %)
2 2  BMS Mini S / BMS Mini 2 firmware update procedure is described [[here>>doc:Battery management systems.BMS Mini S.5\. Firmware update.WebHome]].
3 3  
4 -= v1.6.0 =
4 +(% class="wikigeneratedid" %)
5 +v1.6.0
5 5  
6 6  (% class="wikigeneratedid" %)
7 7  [[BMS_Mini_v1.6.0.srec>>FileManager.BMS_Mini_v1\.6\.0\.srec]]
8 8  
9 -== Features ==
10 +(% class="wikigeneratedid" %)
11 +Features
10 10  
11 11  * new parameter for setting the condition for starting balancing: automatically (regardless of the command) or on the balancing request (see the "Control - Cell balancing" section)
12 12  * new option to start balancing if the cell voltage exceeds the "Voltage for forced balancing" value (see the "Control - Cell balancing" section)
... ... @@ -16,11 +16,13 @@
16 16  * improved control of the precharging contactor, which can precharge capacitive load using multiple attempts and detect high power dissipated in the precharge resistor (see the "Control - Precharge" section)
17 17  * ability to select errors that the device saves in the errors journal (see the "Service - Errors journal" section)
18 18  
19 -== Improvements ==
21 +(% class="wikigeneratedid" %)
22 +Improvements
20 20  
21 21  * placing the device input signals to the "Battery" section and adding raw discrete inputs to the "Signals" section
22 22  
23 -== Fixes ==
26 +(% class="wikigeneratedid" %)
27 +Fixes
24 24  
25 25  * using the calculated open circuit voltage to set/clear the "Ready to charge" and "Ready to discharge" signals
26 26  * resolving the problem of incorrect software signal addresses in the Modbus holding register table