Skip to Content

Changes for page BMS Mini S / BMS Mini

Last modified by Admin on 2026/08/06 14:53
From version 22.1
edited by Admin
on 2026/08/06 14:53
Change comment: There is no comment for this version
To version 17.3
edited by Admin
on 2026/04/22 14:09
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,36 +1,8 @@
1 1  (% class="box infomessage" %)
2 2  (((
3 -BMS Mini S / BMS Mini firmware update procedure is described [[here>>doc:Battery management systems.BMS Mini S.6\. Firmware update.WebHome]].
3 +BMS Mini S / BMS Mini firmware update procedure is described [[here>>doc:Battery management systems.BMS Mini S.5\. Firmware update.WebHome]].
4 4  )))
5 5  
6 -= v1.11.0 =
7 -
8 -[[BMS_Mini_v1.11.0.srec>>FileManager.BMS_Mini_v1\.11\.0\.srec]]
9 -
10 -== Features ==
11 -
12 -* compressing CLI responses for some commands to speed up data exchange over slow interfaces
13 -* support for the Furuisi charger (see the "External equipment - Chargers - Furuisi charger" section)
14 -
15 -== Improvements ==
16 -
17 -* deleting old log files when the SD card is full (see the corresponding flag in the "Service - SD card" section)
18 -* new CAN bus speed is not applied until the device is rebooted
19 -* improved internal current consumption measurement accuracy
20 -
21 -== Fixes ==
22 -
23 -* resolving the issue with the MicroPower charger
24 -* removed support for the BMS Wi-Fi v1
25 -
26 -= v1.10.1 =
27 -
28 -[[BMS_Mini_v1.10.1.srec>>FileManager.BMS_Mini_v1\.10\.1\.srec]]
29 -
30 -== Improvements ==
31 -
32 -* calculating the remaining time until the battery is completely discharged or fully charged
33 -
34 34  = v1.10.0 =
35 35  
36 36  [[BMS_Mini_v1.10.0.srec>>doc:FileManager.BMS_Mini_v1\.10\.0\.srec]]
... ... @@ -37,7 +37,7 @@
37 37  
38 38  == Features ==
39 39  
40 -* new flag to start the heater only if the "Charger connected" signal is set (see the "Control - Heater" section)
12 +* new flag to r
41 41  * new profile section with global battery status, which includes total energy counters, total operating time, contactor switching count, etc. (see the "Profile" tab in the Unified monitor)
42 42  * new error "High board temperature" which is generated when the device overheats (see the "Protection - High board temperature" section)
43 43  * support for sending battery state and events via MQTT protocol via Wi-Fi or cellular network (see the "Service - MQTT" section)