Skip to Content

Changes for page BMS Mini S / BMS Mini

Last modified by Admin on 2026/05/06 12:17
From version 21.1
edited by Admin
on 2026/05/06 12:17
Change comment: There is no comment for this version
To version 18.1
edited by Admin
on 2026/04/22 14:11
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,16 +1,8 @@
1 1  (% class="box infomessage" %)
2 2  (((
3 -BMS Mini S / BMS Mini firmware update procedure is described [[here>>doc:Battery management systems.BMS Mini S.6\. Firmware update.WebHome]].
3 +BMS Mini S / BMS Mini firmware update procedure is described [[here>>doc:Battery management systems.BMS Mini S.5\. Firmware update.WebHome]].
4 4  )))
5 5  
6 -= v1.10.1 =
7 -
8 -[[BMS_Mini_v1.10.1.srec>>FileManager.BMS_Mini_v1\.10\.1\.srec]]
9 -
10 -== Improvements ==
11 -
12 -* calculating the remaining time until the battery is completely discharged or fully charged
13 -
14 14  = v1.10.0 =
15 15  
16 16  [[BMS_Mini_v1.10.0.srec>>doc:FileManager.BMS_Mini_v1\.10\.0\.srec]]
... ... @@ -17,7 +17,7 @@
17 17  
18 18  == Features ==
19 19  
20 -* new flag to start the heater only if the "Charger connected" signal is set (see the "Control - Heater" section)
12 +* new flag to set the "Heater" signal only if "Charger connected" signal is present (see the "Control - Heater" section)
21 21  * new profile section with global battery status, which includes total energy counters, total operating time, contactor switching count, etc. (see the "Profile" tab in the Unified monitor)
22 22  * new error "High board temperature" which is generated when the device overheats (see the "Protection - High board temperature" section)
23 23  * support for sending battery state and events via MQTT protocol via Wi-Fi or cellular network (see the "Service - MQTT" section)