Skip to Content

Changes for page BMS Mini S / BMS Mini

Last modified by Admin on 2026/05/06 12:17
From version 19.1
edited by Admin
on 2026/04/22 14:12
Change comment: There is no comment for this version
To version 21.1
edited by Admin
on 2026/05/06 12:17
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,8 +1,16 @@
1 1  (% class="box infomessage" %)
2 2  (((
3 -BMS Mini S / BMS Mini firmware update procedure is described [[here>>doc:Battery management systems.BMS Mini S.5\. Firmware update.WebHome]].
3 +BMS Mini S / BMS Mini firmware update procedure is described [[here>>doc:Battery management systems.BMS Mini S.6\. Firmware update.WebHome]].
4 4  )))
5 5  
6 += v1.10.1 =
7 +
8 +[[BMS_Mini_v1.10.1.srec>>FileManager.BMS_Mini_v1\.10\.1\.srec]]
9 +
10 +== Improvements ==
11 +
12 +* calculating the remaining time until the battery is completely discharged or fully charged
13 +
6 6  = v1.10.0 =
7 7  
8 8  [[BMS_Mini_v1.10.0.srec>>doc:FileManager.BMS_Mini_v1\.10\.0\.srec]]
... ... @@ -9,7 +9,7 @@
9 9  
10 10  == Features ==
11 11  
12 -* new flag to start the heater only if "Charger connected" signal is set (see the "Control - Heater" section)
20 +* new flag to start the heater only if the "Charger connected" signal is set (see the "Control - Heater" section)
13 13  * new profile section with global battery status, which includes total energy counters, total operating time, contactor switching count, etc. (see the "Profile" tab in the Unified monitor)
14 14  * new error "High board temperature" which is generated when the device overheats (see the "Protection - High board temperature" section)
15 15  * support for sending battery state and events via MQTT protocol via Wi-Fi or cellular network (see the "Service - MQTT" section)