Skip to Content

Changes for page BMS Mini S / BMS Mini

Last modified by Admin on 2025/08/11 16:41
From version 14.1
edited by Admin
on 2025/08/07 16:21
Change comment: There is no comment for this version
To version 15.1
edited by Admin
on 2025/08/11 16:41
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -16,7 +16,6 @@
16 16  * new flags for generating the "Ready to charge" and "Ready to discharge" signals using the actual cell voltage instead of the calculated open circuit voltage (see the "Control - Charging status" and "Control - Discharging status" sections)
17 17  * new flags that force only positive and negative currents to be used to determine open circuit voltages to control the "Ready to charge" and "Ready to discharge" signals respectively
18 18  * new parameter setting a delay before measuring battery current during precharge (see the "Control - Precharge" section)
19 -* new parameter setting a delay before measuring battery current during precharge (see the "Control - Precharge" section)
20 20  * new flag to keep the precharging contactor closed until the precharging process is finished (in this case the "Precharge error" will not occur except for the one caused by high power; see the "Control - Precharge" section)
21 21  * new flag to prevent the "HYG offline" error from occurring if the "Charger connected" signal is set (see the "External equipment - Trucks and Vehicles - HYG Class I-III truck" section)
22 22  * new flag that controls whether to wait for confirmation from the HYG truck or not, to allow the battery to be charged (see the "External equipment - Trucks and Vehicles - HYG Class I-III truck" section)