Skip to Content

Changes for page BMS Main X

Last modified by Admin on 2025/02/19 08:28
From version 1.1
edited by Admin
on 2024/11/22 08:56
Change comment: There is no comment for this version
To version 4.1
edited by Admin
on 2024/12/17 12:53
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,0 +1,46 @@
1 += v2.6.3 =
2 +
3 +[[BMS_Main_X2_v2.6.3.srec>>FileManager.BMS_Main_X2_v2\.6\.3\.srec]]
4 +
5 +== Improvements ==
6 +
7 +* adaptation of the device to the production test bench
8 +
9 += v2.6.2 =
10 +
11 +[[BMS_Main_X2_v2.6.2.srec>>FileManager.BMS_Main_X2_v2\.6\.2\.srec]]
12 +
13 +== Fixes ==
14 +
15 +* resolving the problem of saving device parameters
16 +
17 += v2.6.1 =
18 +
19 +[[BMS_Main_X2_v2.6.1.srec>>FileManager.BMS_Main_X2_v2\.6\.1\.srec]]
20 +
21 +== Fixes ==
22 +
23 +* resolving the issue of preparing battery module states written to Modbus registers
24 +* resolving the problem of writing the device's working time to a non-volatile memory very often
25 +* resolving the problem of returning error states when saving device parameters (mainly via Wi-Fi)
26 +
27 += v2.6.0 =
28 +
29 +[[BMS_Main_X2_v2.6.0.srec>>FileManager.BMS_Main_X2_v2\.6\.0\.srec]]
30 +
31 +== Features ==
32 +
33 +* new parameter to set the minimum number of battery modules allowed to join (see the "Control - Charge" and "Control - Discharge" sections)
34 +* ability to rejoin battery modules if their voltage is close to the battery voltage (see the "Control - Charge" and "Control - Discharge" sections)
35 +* selection of errors that cause reset of contactor control signals (see the "Control - Main contactor", "Control - Charge", "Control - Discharge", "Control - Heater", "Control - Cooler" sections)
36 +* new internal signal "General error (modules)" which is the logical sum of the "General error" signals from the battery modules
37 +* new assignments "Charging", "Precharging", "Discharging", "Charging/Discharging", "Main contactor", "Critical error" and "General error (modules)" for the discrete outputs (see the "Signals - Output discrete signals - Assignments" section)
38 +* new assignments "Critical error" and "General error (modules)" for the relays (see the "Signals - Relays - Assignments" section)
39 +
40 +== Improvements ==
41 +
42 +* rearrangements in the settings sections, which are made to simplify the setup process
43 +
44 +== Fixes ==
45 +
46 +* resolving the problem of device hanging due to high activity on the CAN bus during startup