Wiki source code of BMS Main 3X
Hide last authors
author | version | line-number | content |
---|---|---|---|
![]() |
4.1 | 1 | = v3.1.1 = |
![]() |
1.1 | 2 | |
![]() |
3.1 | 3 | [[BMS_Main_3X_v3.1.1.bin>>FileManager.BMS_Main_3X_v3\.1\.1\.bin]] |
![]() |
1.1 | 4 | |
5 | == Fixes == | ||
6 | |||
7 | * resolving the problem of incorrect range of temperature parameter values (in the "Control - Coolant pump" section) | ||
8 | * resolving the possible problem of saving device parameters | ||
9 | * resolving the problem of writing the device's working time to a non-volatile memory very often | ||
10 | * resolving the issue of preparing battery module states written to Modbus registers | ||
11 | |||
![]() |
4.1 | 12 | = v3.1.0 = |
![]() |
1.1 | 13 | |
![]() |
3.1 | 14 | [[BMS_Main_3X_v3.1.0.bin>>FileManager.BMS_Main_3X_v3\.1\.0\.bin]] |
![]() |
1.1 | 15 | |
![]() |
2.1 | 16 | == Features == |
![]() |
1.1 | 17 | |
18 | * new parameter to set the minimum number of battery modules allowed to join (see the "Control - Charge" and "Control - Discharge" sections) | ||
19 | * ability to rejoin battery modules if their voltage is close to the battery voltage (see the "Control - Charge" and "Control - Discharge" sections) | ||
20 | * selection of errors that cause reset of contactor control signals (see the "Control - Main contactor", "Control - Charge", "Control - Discharge", "Control - Heater", "Control - Cooler", "Control - Coolant pump" sections) | ||
21 | * new internal signal "General error (modules)" which is the logical sum of the "General error" signals from the battery modules | ||
22 | * new assignments "Critical error" and "General error (modules)" for the discrete outputs and power switches (see the "Signals - Output discrete signals - Assignments" and "Signals - Power switches - Assignments" sections) | ||
23 | |||
![]() |
2.1 | 24 | == Improvements == |
![]() |
1.1 | 25 | |
![]() |
2.1 | 26 | * use the measured voltage before contactors as the battery voltage if the "Control - High voltage" function is enabled |
27 | * Unibat: new flag to enable sending a control message to start/stop ventilation fans installed in the battery modules (see the "External equipment - Unibat vehicle" section) | ||
28 | * rearrangements in the settings sections, which are made to simplify the setup process | ||
29 | |||
30 | == Fixes == | ||
31 | |||
32 | * Unibat: minor changes in the communication protocol |