Skip to Content

Changes for page BMS Main 3X

Last modified by Admin on 2025/02/18 14:58
From version 6.2
edited by Admin
on 2024/12/19 12:15
Change comment: There is no comment for this version
To version 3.1
edited by Admin
on 2024/11/18 10:25
Change comment: There is no comment for this version

Summary

Details

Page properties
Tags
... ... @@ -1,1 +1,0 @@
1 -BMS Main 3X
Content
... ... @@ -1,29 +1,5 @@
1 -(% class="wikigeneratedid" %)
2 -BMS Main 3X firmware update procedure is described [[here>>url:https://docs.movicomelectric.com/bin/view/Battery%20management%20systems/BMS%20Main%203/5.%20Firmware%20update/]].
1 += 3.1.1 =
3 3  
4 -(% class="wikigeneratedid" %)
5 -v3.2.0
6 -
7 -(% class="wikigeneratedid" %)
8 -[[BMS_Main_3X_v3.2.0.bin>>FileManager.BMS_Main_3X_v3\.2\.0\.bin]]
9 -
10 -== Features ==
11 -
12 -* new algorithm in the Charging/Discharging controller that allow to control the Charging/Discharging contactor independently from the Charging and Discharging signals (see the "Control - Charge/Discharge" section). The new "Independent" algorithm is preferred in the battery systems with one contactor
13 -* new "Need acknowledge" warning signal that is set when a new record is created in the errors journal. The signal can be cleared in the "Service - Errors journal" section
14 -* new Max-Min algorithm for calculating the final battery SOC in the "Control - Calculation" section
15 -* improved control of the precharging contactor, which can precharge capacitive load using multiple attempts and detect high power dissipated in the precharge resistor (see the "Control - Precharge" section)
16 -* ability to select errors that the device saves in the errors journal (see the "Service - Errors journal" section)
17 -
18 -== Improvements ==
19 -
20 -* ability to finish device initialization even if the number of battery modules found is less than the number of modules enabled
21 -* ability to configure and monitor the device via the CAN1 (ext) bus
22 -* placing the device input signals to the "Battery" section and adding raw discrete inputs to the "Signals" section
23 -* Unibat: support for functional description v3.5 (protocol v1.5)
24 -
25 -= v3.1.1 =
26 -
27 27  [[BMS_Main_3X_v3.1.1.bin>>FileManager.BMS_Main_3X_v3\.1\.1\.bin]]
28 28  
29 29  == Fixes ==
... ... @@ -33,7 +33,7 @@
33 33  * resolving the problem of writing the device's working time to a non-volatile memory very often
34 34  * resolving the issue of preparing battery module states written to Modbus registers
35 35  
36 -= v3.1.0 =
12 += 3.1.0 =
37 37  
38 38  [[BMS_Main_3X_v3.1.0.bin>>FileManager.BMS_Main_3X_v3\.1\.0\.bin]]
39 39