Changes for page BMS Main 3X

Last modified by Admin on 2025/02/18 14:58

From version 6.1
edited by Admin
on 2024/12/13 12:26
Change comment: There is no comment for this version
To version 1.1
edited by Admin
on 2024/11/18 10:24
Change comment: There is no comment for this version

Summary

Details

Page properties
Tags
... ... @@ -1,1 +1,0 @@
1 -BMS Main 3X
Content
... ... @@ -1,10 +1,7 @@
1 -(% class="wikigeneratedid" %)
2 -BMS Main 3X firmware update procedure is described [[here>>url:https://docs.movicomelectric.com/bin/view/Battery%20management%20systems/BMS%20Main%203/5.%20Firmware%20update/]].
1 += 3.1.1 =
3 3  
4 -= v3.1.1 =
3 +...
5 5  
6 -[[BMS_Main_3X_v3.1.1.bin>>FileManager.BMS_Main_3X_v3\.1\.1\.bin]]
7 -
8 8  == Fixes ==
9 9  
10 10  * resolving the problem of incorrect range of temperature parameter values (in the "Control - Coolant pump" section)
... ... @@ -12,11 +12,11 @@
12 12  * resolving the problem of writing the device's working time to a non-volatile memory very often
13 13  * resolving the issue of preparing battery module states written to Modbus registers
14 14  
15 -= v3.1.0 =
12 +3.1.0
16 16  
17 -[[BMS_Main_3X_v3.1.0.bin>>FileManager.BMS_Main_3X_v3\.1\.0\.bin]]
14 +...
18 18  
19 -== Features ==
16 +Features
20 20  
21 21  * new parameter to set the minimum number of battery modules allowed to join (see the "Control - Charge" and "Control - Discharge" sections)
22 22  * ability to rejoin battery modules if their voltage is close to the battery voltage (see the "Control - Charge" and "Control - Discharge" sections)
... ... @@ -24,12 +24,8 @@
24 24  * new internal signal "General error (modules)" which is the logical sum of the "General error" signals from the battery modules
25 25  * new assignments "Critical error" and "General error (modules)" for the discrete outputs and power switches (see the "Signals - Output discrete signals - Assignments" and "Signals - Power switches - Assignments" sections)
26 26  
27 -== Improvements ==
24 +Improvements
28 28  
29 -* use the measured voltage before contactors as the battery voltage if the "Control - High voltage" function is enabled
30 -* Unibat: new flag to enable sending a control message to start/stop ventilation fans installed in the battery modules (see the "External equipment - Unibat vehicle" section)
31 -* rearrangements in the settings sections, which are made to simplify the setup process
32 -
33 -== Fixes ==
34 -
35 -* Unibat: minor changes in the communication protocol
26 +- use the measured voltage before contactors as the battery voltage if the "Control - High voltage" function is enabled
27 +- Unibat: new flag to enable sending a control message to start/stop ventilation fans installed in the battery modules (see the "External equipment - Unibat vehicle" section)
28 +- rearrangements in the settings sections, which are made to simplify the setup process