Skip to Content

Changes for page BMS Main 3X

Last modified by Admin on 2025/02/18 14:58
From version 4.1
edited by Admin
on 2024/11/18 10:25
Change comment: There is no comment for this version
To version 1.1
edited by Admin
on 2024/11/18 10:24
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,6 +1,6 @@
1 -= v3.1.1 =
1 += 3.1.1 =
2 2  
3 -[[BMS_Main_3X_v3.1.1.bin>>FileManager.BMS_Main_3X_v3\.1\.1\.bin]]
3 +...
4 4  
5 5  == Fixes ==
6 6  
... ... @@ -9,11 +9,11 @@
9 9  * resolving the problem of writing the device's working time to a non-volatile memory very often
10 10  * resolving the issue of preparing battery module states written to Modbus registers
11 11  
12 -= v3.1.0 =
12 +3.1.0
13 13  
14 -[[BMS_Main_3X_v3.1.0.bin>>FileManager.BMS_Main_3X_v3\.1\.0\.bin]]
14 +...
15 15  
16 -== Features ==
16 +Features
17 17  
18 18  * new parameter to set the minimum number of battery modules allowed to join (see the "Control - Charge" and "Control - Discharge" sections)
19 19  * ability to rejoin battery modules if their voltage is close to the battery voltage (see the "Control - Charge" and "Control - Discharge" sections)
... ... @@ -21,12 +21,8 @@
21 21  * new internal signal "General error (modules)" which is the logical sum of the "General error" signals from the battery modules
22 22  * new assignments "Critical error" and "General error (modules)" for the discrete outputs and power switches (see the "Signals - Output discrete signals - Assignments" and "Signals - Power switches - Assignments" sections)
23 23  
24 -== Improvements ==
24 +Improvements
25 25  
26 -* use the measured voltage before contactors as the battery voltage if the "Control - High voltage" function is enabled
27 -* Unibat: new flag to enable sending a control message to start/stop ventilation fans installed in the battery modules (see the "External equipment - Unibat vehicle" section)
28 -* rearrangements in the settings sections, which are made to simplify the setup process
29 -
30 -== Fixes ==
31 -
32 -* Unibat: minor changes in the communication protocol
26 +- use the measured voltage before contactors as the battery voltage if the "Control - High voltage" function is enabled
27 +- Unibat: new flag to enable sending a control message to start/stop ventilation fans installed in the battery modules (see the "External equipment - Unibat vehicle" section)
28 +- rearrangements in the settings sections, which are made to simplify the setup process