Skip to Content

Changes for page BMS Main 3X

Last modified by Admin on 2026/02/18 13:39
From version 22.1
edited by Admin
on 2026/02/05 03:31
Change comment: There is no comment for this version
To version 21.2
edited by Admin
on 2026/02/05 03:31
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -7,18 +7,18 @@
7 7  
8 8  [[BMS_Main_3X_v3.8.1.bin>>FileManager.BMS_Main_3X_v3\.8\.1\.bin]]
9 9  
10 -== Improvements ==
10 +Improvements
11 11  
12 -* setting and clearing the "Voltage unbalance" errors without delays
13 -* new CAN bus speed is not applied until the device is rebooted
14 -* logging the following new parameters: "UnibatState", "UnibatOperationalModeState", "Keyrun", "ChargeOn"
15 -* Unibat: ability to shutdown the battery if its SOC is too low (see the "External equipment - Unibat vehicle - Diagnostic parameters" section)
16 -* Unibat: change the resolution of parameters CC and DC from 0.01 to 0.1 Ah/bit
17 -* Unibat: do not turn on the amber lamp if the actual battery SOC is equal to the configured maximum operational SOC
12 +setting and clearing the "Voltage unbalance" errors without delays
13 +{new CAN bus speed is not applied until the device is rebooted
14 +- logging the following new parameters: "UnibatState", "UnibatOperationalModeState", "Keyrun", "ChargeOn"
15 +- Unibat: ability to shutdown the battery if its SOC is too low (see the "External equipment - Unibat vehicle - Diagnostic parameters" section)
16 +- Unibat: change the resolution of parameters CC and DC from 0.01 to 0.1 Ah/bit
17 +- Unibat: do not turn on the amber lamp if the actual battery SOC is equal to the configured maximum operational SOC
18 18  
19 -== Fixes ==
19 +Fixes
20 20  
21 -* resolving the problem of completing the initialization process before the power switch voltage stabilizes
21 +- resolving the problem of completing the initialization process before the power switch voltage stabilizes
22 22  
23 23  = v3.8.0 =
24 24