Skip to Content

Changes for page BMS Main 3X

Last modified by Admin on 2025/10/27 11:43
From version 17.1
edited by Admin
on 2025/10/06 04:50
Change comment: There is no comment for this version
To version 18.1
edited by Admin
on 2025/10/27 11:43
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -3,6 +3,23 @@
3 3  BMS Main 3X firmware update procedure is described [[here>>doc:Battery management systems.BMS Main 3.5\. Firmware update.WebHome]].
4 4  )))
5 5  
6 += v3.6.2 =
7 +
8 +[[BMS_Main_3X_v3.6.2.bin>>FileManager.BMS_Main_3X_v3\.6\.2\.bin]]
9 +
10 +== Improvements ==
11 +
12 +* turning on power switches with a delay of 1 second after reaching the supply voltage of 9V
13 +* Unibat: new flag that allows to hide the insulation testing status when repeating measurements (see the "External equipment - Unibat vehicle" section)
14 +* expansion of the list of parameters that are reset to default values when the device is powered on while holding the button on the board. The following parameters are affected: all CAN1 (ext) settings; all CAN2 (int) settings; all CAN3 (BMS) settings; all RS-485-1 (Modbus) settings; LAN settings: IP mode, IP address, Netmask, Gateway address
15 +
16 +== Fixes ==
17 +
18 +* resolving the issue of false warnings indicating that the battery current exceeds the current limits (affects Unibat vehicle)
19 +* Unibat: changes that make it so that the output period is responsible for only 4 messages, not for all messages (see the "External equipment - Unibat vehicle" section)
20 +* Unibat: resolving the issue of TP messages not being sent if the transport is already transmitting something at the time of the request
21 +* corrections of typos in parameter descriptions
22 +
6 6  = v3.6.1 =
7 7  
8 8  [[BMS_Main_3X_v3.6.1.bin>>FileManager.BMS_Main_3X_v3\.6\.1\.bin]]