Skip to Content

Changes for page BMS Main 3X

Last modified by Admin on 2025/10/27 11:43
From version 15.1
edited by Admin
on 2025/09/03 10:30
Change comment: There is no comment for this version
To version 17.1
edited by Admin
on 2025/10/06 04:50
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -3,6 +3,30 @@
3 3  BMS Main 3X firmware update procedure is described [[here>>doc:Battery management systems.BMS Main 3.5\. Firmware update.WebHome]].
4 4  )))
5 5  
6 += v3.6.1 =
7 +
8 +[[BMS_Main_3X_v3.6.1.bin>>FileManager.BMS_Main_3X_v3\.6\.1\.bin]]
9 +
10 +== Improvements ==
11 +
12 +* new parameters for switching to the sum of battery modules' currents if the current sensor error is detected or the sensor is saturated (see the "Inputs - Current sensor" section)
13 +* new flag allowing to swap CAN2 (int) and CAN3 (BMS) interfaces (see the "Connectivity" section under the service account)
14 +
15 += v3.6.0 =
16 +
17 +[[BMS_Main_3X_v3.6.0.bin>>FileManager.BMS_Main_3X_v3\.6\.0\.bin]]
18 +
19 +== Features ==
20 +
21 +* Unibat: refined algorithms and new parameters to meet requirements of version 8.5 of the logic (protocol v6.1)
22 +
23 +== Improvements ==
24 +
25 +* new flag enabling fast current measurements (see the "Signals - Current sensor" section)
26 +* new parameters to ignore the specified errors when setting the critical error (see the "Protections - Critical error" section)
27 +* displaying HV calibration values for the service account (see the "Service - Calibration" section)
28 +* Unibat: structuring parameters into subgroups: "General parameters", "Battery parameters", "Diagnostic parameters", "Power limiting parameters", "Battery version" (see the "External equipment - Unibat vehicle" section)
29 +
6 6  = v3.5.0 =
7 7  
8 8  [[BMS_Main_3X_v3.5.0.bin>>FileManager.BMS_Main_3X_v3\.5\.0\.bin]]