Skip to Content

Changes for page BMS Main 3X

Last modified by Admin on 2025/05/28 11:01
From version 12.1
edited by Admin
on 2025/05/28 11:01
Change comment: There is no comment for this version
To version 10.1
edited by Admin
on 2025/03/20 05:09
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -3,41 +3,6 @@
3 3  BMS Main 3X firmware update procedure is described [[here>>doc:Battery management systems.BMS Main 3.5\. Firmware update.WebHome]].
4 4  )))
5 5  
6 -= v3.2.5 =
7 -
8 -[[BMS_Main_3X_v3.2.5.bin>>FileManager.BMS_Main_3X_v3\.2\.5\.bin]]
9 -
10 -== Improvements ==
11 -
12 -* dynamic calculation of data transfer schedule for optimal communication with a large number of battery modules
13 -* ability to complete device initialization after the set timeout has expired and the minimum number of modules has been detected (see the "Control - Initialization" section)
14 -* 30 second delay when remounting SD card after detecting mount error
15 -* saving the number of joined modules in log files
16 -* Unibat: new flag disabling insulation measurement
17 -* Unibat: calculation of the battery current depending on the connection variant of current sensors
18 -* Unibat: preventing HVILS changes if the battery is in power-down state
19 -
20 -== Fixes ==
21 -
22 -* resolving the problem of ignoring the parameter that selects the connection variant of current sensors
23 -* Unibat: corrections in message identifiers HVESSS1, HVESSD2, HVESSD3, HVESSD8, storing battery module data
24 -* Unibat: corrections in HVESSCFG message priority
25 -
26 -= v3.2.4 =
27 -
28 -[[BMS_Main_3X_v3.2.4.bin>>FileManager.BMS_Main_3X_v3\.2\.4\.bin]]
29 -
30 -== Improvements ==
31 -
32 -* new flags that allow to interrupt (shorten) the module balancing stage if all battery modules are already joined (see the "Control - Charge", "Control - Discharge", "Control - Charge/Discharge" sections)
33 -* forwarding CLI and bootloader CAN messages from CAN1 interface to CAN2 interface and back, that allows the user to configure and update the firmware of internal devices such as BMS IMD or BMS Display
34 -* new parameter for setting the type of network to which the BMS GSM communication module connects (see the "Connectivity - Cellular" section)
35 -
36 -== Fixes ==
37 -
38 -* Unibat: resolving the problem of calculating the CRC of the HVESSS1 message
39 -* Unibat: resolving the problem of sending a message about battery disconnection even it is already disconnected
40 -
41 41  = v3.2.3 =
42 42  
43 43  [[BMS_Main_3X_v3.2.3.bin>>FileManager.BMS_Main_3X_v3\.2\.3\.bin]]