Changes for page BMS Main 3X

Last modified by Admin on 2025/02/18 14:58

From version 1.1
edited by Admin
on 2024/11/18 10:24
Change comment: There is no comment for this version
To version 6.1
edited by Admin
on 2024/12/13 12:26
Change comment: There is no comment for this version

Summary

Details

Page properties
Tags
... ... @@ -1,0 +1,1 @@
1 +BMS Main 3X
Content
... ... @@ -1,7 +1,10 @@
1 -= 3.1.1 =
1 +(% class="wikigeneratedid" %)
2 +BMS Main 3X firmware update procedure is described [[here>>url:https://docs.movicomelectric.com/bin/view/Battery%20management%20systems/BMS%20Main%203/5.%20Firmware%20update/]].
2 2  
3 -...
4 += v3.1.1 =
4 4  
6 +[[BMS_Main_3X_v3.1.1.bin>>FileManager.BMS_Main_3X_v3\.1\.1\.bin]]
7 +
5 5  == Fixes ==
6 6  
7 7  * resolving the problem of incorrect range of temperature parameter values (in the "Control - Coolant pump" section)
... ... @@ -9,11 +9,11 @@
9 9  * resolving the problem of writing the device's working time to a non-volatile memory very often
10 10  * resolving the issue of preparing battery module states written to Modbus registers
11 11  
12 -3.1.0
15 += v3.1.0 =
13 13  
14 -...
17 +[[BMS_Main_3X_v3.1.0.bin>>FileManager.BMS_Main_3X_v3\.1\.0\.bin]]
15 15  
16 -Features
19 +== Features ==
17 17  
18 18  * new parameter to set the minimum number of battery modules allowed to join (see the "Control - Charge" and "Control - Discharge" sections)
19 19  * ability to rejoin battery modules if their voltage is close to the battery voltage (see the "Control - Charge" and "Control - Discharge" sections)
... ... @@ -21,8 +21,12 @@
21 21  * new internal signal "General error (modules)" which is the logical sum of the "General error" signals from the battery modules
22 22  * new assignments "Critical error" and "General error (modules)" for the discrete outputs and power switches (see the "Signals - Output discrete signals - Assignments" and "Signals - Power switches - Assignments" sections)
23 23  
24 -Improvements
27 +== Improvements ==
25 25  
26 -- use the measured voltage before contactors as the battery voltage if the "Control - High voltage" function is enabled
27 -- Unibat: new flag to enable sending a control message to start/stop ventilation fans installed in the battery modules (see the "External equipment - Unibat vehicle" section)
28 -- rearrangements in the settings sections, which are made to simplify the setup process
29 +* use the measured voltage before contactors as the battery voltage if the "Control - High voltage" function is enabled
30 +* Unibat: new flag to enable sending a control message to start/stop ventilation fans installed in the battery modules (see the "External equipment - Unibat vehicle" section)
31 +* rearrangements in the settings sections, which are made to simplify the setup process
32 +
33 +== Fixes ==
34 +
35 +* Unibat: minor changes in the communication protocol