Changes for page BMS Main 3

Last modified by Admin on 2025/02/18 14:57

From version 2.1
edited by Admin
on 2024/11/18 10:16
Change comment: There is no comment for this version
To version 1.2
edited by Admin
on 2024/11/18 10:15
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -9,18 +9,4 @@
9 9  * resolving the possible problem of saving device parameters
10 10  * resolving the problem of writing the device's working time to a non-volatile memory very often
11 11  
12 -= 2.1.0 =
13 -
14 -== Features ==
15 -
16 -* new algorithms in the Charging/Discharging controller that allow to control the Charging/Discharging contactor independently from the Charging and Discharging signals (see the "Control - Charge/Discharge" section). The new "Independent" algorithms are preferred in the battery systems with one contactor.
17 -* selection of errors that cause reset of contactor control signals (see the "Control - Main contactor", "Control - Charge", "Control - Discharge", "Control - Charge/Discharge", "Control - Discharge (AUX)", "Control - Heater", "Control - Cooler", "Protections - General error", "Control - Charging status", "Control - Discharging status" sections)
18 -* new "Current limit error" which is set if the battery current exceeds the charging or discharging current limits (see the "Protections - Charge current limit" and "Protections - Discharge current limit" sections)
19 -* new parameter to select the method of calculating the battery voltage: sum the cell voltages or use the measured voltage before contactors (see the "Control - Common settings" section)
20 -* clearing the Discharging (AUX) signal if the cell voltage is too low (see the "Control - Discharge (AUX)" section)
21 -* new assignment "Close External 1" for the discrete inputs (see the "Signals - Input discrete signals - Assignments" section)
22 -* new assignment "External 1" for the discrete outputs and power switches (see the "Signals - Output discrete signals - Assignments" and "Signals - Power switches - Assignments" sections). The "External 1" output is directly controlled by the "Close External 1" command.
23 -
24 -== Improvements ==
25 -
26 -* rearrangements in the settings sections, which are made to simplify the setup process
12 +2.1.1