Skip to Content

Changes for page BMS Main 3

Last modified by Admin on 2025/12/10 16:23
From version 19.1
edited by Admin
on 2025/10/03 09:00
Change comment: There is no comment for this version
To version 20.1
edited by Admin
on 2025/10/27 11:42
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -3,6 +3,20 @@
3 3  BMS Main 3 firmware update procedure is described [[here>>doc:Battery management systems.BMS Main 3.5\. Firmware update.WebHome]].
4 4  )))
5 5  
6 += v2.7.1 =
7 +
8 +[[BMS_Main_3_v2.7.1.bin>>FileManager.BMS_Main_3_v2\.7\.1\.bin]]
9 +
10 +== Improvements ==
11 +
12 +* turning on power switches with a delay of 1 second after reaching the supply voltage of 9V
13 +* ability to generate the "Logic count error" also during BMS initialization (scanning of BMS Logic devices); new parameters for setting delays before/after generating/clearing the error (see the "Protections - Logic count" section)
14 +* expansion of the list of parameters that are reset to default values when the device is powered on while holding the button on the board. The following parameters are affected: all CAN1 (ext) settings; all CAN2 (int) settings; all RS-485-1 (Modbus) settings; LAN settings: IP mode, IP address, Netmask, Gateway address
15 +
16 +== Fixes ==
17 +
18 +* small fixes in dynamic current maps
19 +
6 6  = v2.7.0 =
7 7  
8 8  [[BMS_Main_3_v2.7.0.bin>>FileManager.BMS_Main_3_v2\.7\.0\.bin]]