Skip to Content

Changes for page BMS Main 2.1

Last modified by Admin on 2026/01/30 09:17
From version 14.2
edited by Admin
on 2025/08/07 15:26
Change comment: There is no comment for this version
To version 17.1
edited by Admin
on 2026/01/30 09:17
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -3,6 +3,30 @@
3 3  BMS Main 2.1 firmware update procedure is described [[here>>doc:Battery management systems.BMS Main 2\.1.4\. Firmware update.WebHome]].
4 4  )))
5 5  
6 += v1.70.6 =
7 +
8 +[[BMS_Main_2.1_v1.70.6.srec>>FileManager.BMS_Main_2\.1_v1\.70\.6\.srec]]
9 +
10 +== Improvements ==
11 +
12 +* support for 32-bit BMS Logic serial numbers
13 +* increasing the stability of the BMS Wi-Fi v2 driver
14 +
15 +== Fixes ==
16 +
17 +* resolving the problem of charge, discharge, and charge/discharge contactors closing when the "Precharge request" signal is set
18 +* synchronization of the precharge procedure with the charge/discharge algorithms, so that precharge is stopped if charging and discharging are prohibited
19 +* resolving the stability problem when the SD card is full
20 +* small fixes in current maps
21 +
22 += v1.70.5 =
23 +
24 +[[BMS_Main_2.1_v1.70.5.srec>>FileManager.BMS_Main_2\.1_v1\.70\.5\.srec]]
25 +
26 +== Fixes ==
27 +
28 +* resolving the issue of Ethernet packet retransmission
29 +
6 6  = v1.70.4 =
7 7  
8 8  [[BMS_Main_2.1_v1.70.4.srec>>FileManager.BMS_Main_2\.1_v1\.70\.4\.srec]]
... ... @@ -9,11 +9,11 @@
9 9  
10 10  == Improvements ==
11 11  
12 -new flags for generating the "Ready to charge" and "Ready to discharge" signals using the actual cell voltage instead of the calculated open circuit voltage (see the "Cells - Charging control" and "Cells - Discharging control" sections)
36 +* new flags for generating the "Ready to charge" and "Ready to discharge" signals using the actual cell voltage instead of the calculated open circuit voltage (see the "Cells - Charging control" and "Cells - Discharging control" sections)
13 13  
14 -Fixes
38 +== Fixes ==
15 15  
16 -resolving the issue of rebooting the device if formatting the SD card is activated
40 +* resolving the issue of rebooting the device if formatting the SD card is activated
17 17  
18 18  = v1.70.3 =
19 19