Skip to Content

Changes for page BMS Main 2.1

Last modified by Admin on 2025/08/12 14:43
From version 13.1
edited by Admin
on 2025/05/29 14:02
Change comment: There is no comment for this version
To version 14.2
edited by Admin
on 2025/08/07 15:26
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -3,6 +3,29 @@
3 3  BMS Main 2.1 firmware update procedure is described [[here>>doc:Battery management systems.BMS Main 2\.1.4\. Firmware update.WebHome]].
4 4  )))
5 5  
6 += v1.70.4 =
7 +
8 +[[BMS_Main_2.1_v1.70.4.srec>>FileManager.BMS_Main_2\.1_v1\.70\.4\.srec]]
9 +
10 +== Improvements ==
11 +
12 +new flags for generating the "Ready to charge" and "Ready to discharge" signals using the actual cell voltage instead of the calculated open circuit voltage (see the "Cells - Charging control" and "Cells - Discharging control" sections)
13 +
14 +Fixes
15 +
16 +resolving the issue of rebooting the device if formatting the SD card is activated
17 +
18 += v1.70.3 =
19 +
20 +[[BMS_Main_2.1_v1.70.3.srec>>FileManager.BMS_Main_2\.1_v1\.70\.3\.srec]]
21 +
22 +== Improvements ==
23 +
24 +* new flags that force the precharge process to finish if the battery current is negative (in case the battery will be charging) or positive (in case the battery will be discharging); see the "Cells - Charging control" and "Cells - Discharging control" sections
25 +* 30 second delay when remounting SD card after detecting mount error
26 +* new flag to prevent the "HYG offline" error from occurring if the "Charger connected" signal is set (see the "External equipment - HYG Class I-III truck" section)
27 +* new flag that controls whether to wait for confirmation from the HYG truck or not, to allow the battery to be charged (see the "External equipment - HYG Class I-III truck" section)
28 +
6 6  = v1.70.2 =
7 7  
8 8  [[BMS_Main_2.1_v1.70.2.srec>>FileManager.BMS_Main_2\.1_v1\.70\.2\.srec]]