Skip to Content

Changes for page BMS Main 2.1

Last modified by Admin on 2025/04/14 10:35
From version 1.1
edited by Admin
on 2024/11/22 09:02
Change comment: There is no comment for this version
To version 4.1
edited by Admin
on 2024/12/11 12:47
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,0 +1,34 @@
1 +(% class="wikigeneratedid" %)
2 +BMS Main 2.1 firmware upgrade procedure is described [[here>>doc:Battery management systems.BMS Main 2\.1.4\. Firmware update.WebHome]].
3 +
4 += v1.67.0 =
5 +
6 +[[BMS_Main_2.1_v1.67.0.srec>>FileManager.BMS_Main_2\.1_v1\.67\.0\.srec]]
7 +
8 +== Features ==
9 +
10 +* new additional heater controller (see the "Protections - Heater (AUX) control" section), which generates the "Heater (AUX)" signal, which can be assigned to a discrete output or relay
11 +
12 +== Improvements ==
13 +
14 +* new balancing strategy that attempts to keep the temperature of BMS Logic devices below a set value by discharging cells with higher voltages first than others (see the "Cells - Cell balancing" section)
15 +
16 += v1.66.1 =
17 +
18 +[[BMS_Main_2.1_v1.66.1.srec>>FileManager.BMS_Main_2\.1_v1\.66\.1\.srec]]
19 +
20 +== Improvements ==
21 +
22 +* closing all TCP connections over Ethernet if the interface link is down
23 +
24 += v1.66.0 =
25 +
26 +[[BMS_Main_2.1_v1.66.0.srec>>FileManager.BMS_Main_2\.1_v1\.66\.0\.srec]]
27 +
28 +== Features ==
29 +
30 +* support for the insulation monitoring device BMS IMD (see the section "External equipment - BMS IMD device")
31 +
32 +== Improvements ==
33 +
34 +* new parameters for switching off the Discharging (AUX) relay when the cell voltage is too low (see the "Cells - Discharging (AUX) control" section)