Changes for page 4.5 External equipment

Last modified by Admin on 2025/02/27 10:23

From version 3.2

edited by Admin
on 2025/02/27 10:15

Change comment: There is no comment for this version

To version 3.1

edited by Admin
on 2025/02/27 10:15

Change comment: Загрузить новое вложение 1740651353463-581.png

Summary

Page properties

Content

@@ -190,25 +190,8 @@
  In this section:
--* Enable – a flag to enable communication with the inverter;
--* CAN port – port which is used to communicate with the inverter:
--** CAN1 (ext);
--** CAN2 (int);
--* Receive timeout – a timeout for receiving packets from the inverter (if no data is being received from the inverter during this time, the connection loss flag is set), millisecond;
--* Output period – a period of sending commands to the inverter, millisecond;
--* Charge voltage, V – maximum charging voltage, V;
--* Charge current, А – maximum charging current, A;
--* Discharge voltage (min) – minimum discharging voltage, V;
--* Discharge current – maximum discharging current, А;
--* Invert current – a flag to inverse current sent to the inverter;
++* Voltage, V.
--When working with the Sunny Island inverter, the BMS Main 3 device sends messages with the values of voltage and charge/discharge current continuously with the period “Output period”: Charging voltage, Charging current, Discharging voltage, Discharging current.
--
--=== Pylontech inverter ===
--
--To change the parameters of communication with a Pylontech inverter, select the "External equipment → Inverters and loads → Pylontech inverter" section:
--
--
  === HYG Class I-III truck ===
  Information about the status of communication with a HYG Class I-III truck is available in the "External equipment → Trucks and Vehicles → HYG Class I-III truck" section: