Skip to Content

Changes for page 3.4 Protections

Last modified by Admin on 2025/04/09 12:23
From version 9.1
edited by Admin
on 2025/02/26 12:44
Change comment: There is no comment for this version
To version 7.2
edited by Admin
on 2025/02/26 12:07
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -545,15 +545,11 @@
545 545  
546 546  To change the insulation monitoring parameters, select the "Protections → Insulation" section:
547 547  
548 -[[image:1740573733492-485.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="119" width="800"]]
548 +[[image:1733748083469-478.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="102" width="800"]]
549 549  
550 550  In this section:
551 551  
552 552  * Enable – a flag to enable the protection;
553 -* Checking algorithm – isolation checking mode:
554 -** Always on – check is always performed;
555 -** On charging – check is performed only if “Charger connected” or “Charge request” is set;
556 -** Except charging - check is performed only if “Charger connected” and “Charge request” are cleared;
557 557  * Delay before setting the error, second;
558 558  * Delay before clearing the error, second;
559 559  * Lock – a flag to block the error until the device is restarted.
... ... @@ -573,6 +573,21 @@
573 573  * Delay before clearing the error, second;
574 574  * Lock – a flag to block the error until the device is restarted.
575 575  
576 -The "Critical error" signal is generated if at least one of the critical errors (see [[Errors>>doc:Battery management systems.Additional information.1\. Battery controllers\: signals and errors.WebHome||anchor="HErrors"]]) is generated during the “Delay before setting the error” time.
572 +The critical error flag is generated if at least one of the following errors is generated during the “Delay before setting the error” time:
577 577  
574 +* “Battery cover error”;
575 +* “Cell monitor offline”;
576 +* “Cell count error”;
577 +* “ADC error”;
578 +* “Current sensor error”;
579 +* “Shunt offline”;
580 +* “Shunt error”;
581 +* “No temp. sensors”;
582 +* “Temp. sensor is shorted”;
583 +* “Settings error”;
584 +* “WDT reset”;
585 +* “Stuck contactor”;
586 +* “Contactor feedback error”;
587 +* “Insulation fault”.
588 +
578 578  The “Critical error” is cleared if there are no errors from the list above during the “Delay before clearing the error” time.
1740573733492-485.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.admin
Size
... ... @@ -1,1 +1,0 @@
1 -23.4 KB
Content