Skip to Content

Changes for page 3.2 Inputs and outputs

Last modified by Admin on 2025/02/24 11:11
From version 2.4
edited by Admin
on 2024/12/11 13:11
Change comment: Update document after refactoring.
To version 3.3
edited by Admin
on 2025/01/28 14:43
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -74,9 +74,8 @@
74 74  * Invert – a flag to invert current values;
75 75  * Receive timeout – a timeout for receiving messages from BMS Current Sensor (if no data is being received from the current sensor during this time, the “Shunt offline” flag is set), millisecond;
76 76  * Mean value threshold – T,,M,, level, A (if module of instantaneous current (I,,I,,) which is received from the shunt sensor is between T,,M,, and T,,0,,, the BMS will use mean value of current I,,M,,; if I,,I,, is greater than T,,M,,, the BMS will use instantaneous value of current I,,I,,);
77 +* Zero threshold – T,,0,, level, A (if module of instantaneous current (I,,I,,) which is received from the shunt sensor is lower than T,,0,,, the BMS will assume that current flowing through the battery is zero);
77 77  
78 -Zero threshold – T,,0,, level, A (if module of instantaneous current (I,,I,,) which is received from the shunt sensor is lower than T,,0,,, the BMS will assume that current flowing through the battery is zero);
79 -
80 80  === Temperature sensor ===
81 81  
82 82  Temperature sensors settings are configured in the "Signals → Temperature sensors" section:
... ... @@ -141,8 +141,14 @@
141 141  
142 142  === Wire resistance compensation ===
143 143  
144 -The BMS Mini is powered directly from the battery. This causes the voltages of the first and last battery cells to be measured with an error, the magnitude of which is proportional to the current drawn by the BMS and the resistance of the wires connecting these cells to the BMS. To compensate for the cell voltage measurement error, the BMS Mini provides a wire resistance setting.
143 +(% class="box warningmessage" %)
144 +(((
145 +**Warning!**
146 +This section applies only to **BMS Mini S v1.0 **and **BMS Mini v2.0 (device)**.
147 +)))
145 145  
149 +The BMS Mini is powered directly from the battery. This causes the voltages of th fisrt and the last cells to be measured with an error, the magnitude of which is proportional to the current drawn by the BMS and the resistance of the wires connecting these cells to the BMS. To compensate for the cell voltage measurement error, the BMS Mini provides a wire resistance setting.
150 +
146 146  Setting the resistance of the wires connecting the first and last cells of the battery with the BMS is performed in the “Signals → Wire resistance compensation” section:
147 147  
148 148  [[image:1733743676800-295.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="102" width="800"]]