Skip to Content

Changes for page 3.3 Control

Last modified by Admin on 2025/05/30 16:50
From version 9.1
edited by Admin
on 2025/01/28 16:17
Change comment: Загрузить новое вложение 1738081025199-282.png
To version 9.2
edited by Admin
on 2025/01/28 16:18
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -174,7 +174,7 @@
174 174  
175 175  The battery charge management is configured in the "Control → Charge" section:
176 176  
177 -[[image:1734089684907-463.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="180" width="600"]]
177 +[[image:1738081025199-282.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="162" width="600"]]
178 178  
179 179  In this section:
180 180  
... ... @@ -193,8 +193,8 @@
193 193  * Disconnect modules that are not ready to charge – a flag for disconnecting modules that have the “Ready to charge” signal cleared.
194 194  * Disconnect all modules if one is not ready to charge – a flag for disconnecting all modules if any of the modules have the “Ready to charge” signal cleared;
195 195  * Join modules on the “Charge request” signal – a flag to enable automatic modules joining if “Charge request” signal appears;
196 +* Maximum CONTINUOUS charge current limit – a maximum continuous allowed charging current of all battery, A;
196 196  * Maximum charge current limit – a maximum allowed charging current of all battery, A;
197 -* Maximum charge current limit – a maximum allowed charging current of all battery, A;
198 198  * Errors 1 (2) to disconnect all battery modules – errors that cause all battery modules to be disconnected from the common bus;
199 199  * Errors 1 (2) to open the charging contactor – errors that cause the main charging contactor "Charging" to open;
200 200  * Switch of the charging contactor on errors without a delay – a flag that allows the main charging contactor “Charging” to be opened without delay if errors are detected.