Skip to Content

Changes for page 3.3 Control

Last modified by Admin on 2025/05/30 16:50
From version 35.2
edited by Admin
on 2025/03/20 12:57
Change comment: There is no comment for this version
To version 35.3
edited by Admin
on 2025/03/20 12:57
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -173,7 +173,7 @@
173 173  The command to turn on the main charging contactor "Charging" can be issued either to the upper-level system via the CAN1 (ext) bus, or to the intelligent switch of the device, which serves for direct control of the main charging contactor "Charging".
174 174  
175 175  
176 -In addition to controlling the charging contactors, the charge controller calculates and transmits to the upper-level system the value of the maximum allowable current, which can be used to charge the modular battery (“Charge current limit”). The calculation of the charging current of the entire battery is performed based on the number of battery modules operating per charge and the values of the current limits transmitted by them – total current takes equal to minimum current limit among the modules times the number of modules. Also there is an ability to regulate the total curent
176 +In addition to controlling the charging contactors, the charge controller calculates and transmits to the upper-level system the value of the maximum allowable current, which can be used to charge the modular battery (“Charge current limit”). The calculation of the charging current of the entire battery is performed based on the number of battery modules operating per charge and the values of the current limits transmitted by them – total current takes equal to minimum current limit among the modules times the number of modules. Also there is an ability to regulate the total curent tha
177 177  
178 178  
179 179  The battery charge management is configured in the "Control → Charge" section: