Skip to Content

Changes for page 3.3 Control

Last modified by Admin on 2025/05/30 16:50
From version 21.1
edited by Admin
on 2025/02/19 14:46
Change comment: Uploaded new attachment "1739976370994-390.png", version {1}
To version 22.1
edited by Admin
on 2025/02/19 14:46
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -18,15 +18,15 @@
18 18  
19 19  Flags for enabling battery modules are configured in the "Control → Modules → Enable (modules 1 to 8)" and "Control → Modules → Enable (modules 9 to 32)" section:
20 20  
21 -[[image:1734023979582-179.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="165" width="600"]]
22 22  
22 +[[image:1739976358691-364.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="164" width="600"]]
23 23  The network addresses of the battery modules are configured in the "Control → Modules → Node IDs (modules 1 to 8)” and "Control → Modules → Node IDs (modules 9 to 32)”:
24 24  
25 -[[image:1734023979583-589.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="186" width="600"]]
26 26  
26 +[[image:1739976370994-390.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="167" width="600"]]
27 27  Each module in a battery must have a unique address. You can change the address in the battery module settings in the “Connectivity → CAN” section of the BMS Main 3 settings.
28 28  
29 -In corresponding section you can set up maximum number of found modules to finish initialization.
29 +In corresponding section you can set up minimum number of found modules to finish initialization.
30 30  
31 31  === Calculation of battery parameters ===
32 32