Skip to Content

Changes for page 3.3 Control

Last modified by Admin on 2025/05/30 16:50
From version 12.25
edited by Admin
on 2025/02/11 16:44
Change comment: There is no comment for this version
To version 12.26
edited by Admin
on 2025/02/11 16:45
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -296,9 +296,10 @@
296 296  The command to turn on the main charging contactor "Discharging" can be issued either to the upper-level system via the CAN1 (ext) bus, or to the intelligent switch of the device, which serves for direct control of the main discharging contactor "Discharging".
297 297  
298 298  
299 -In addition to controlling the charge/discharge contactor, the charge/discharge controller calculates and transmits to the upper-level system the maximum allowable current value with which the modular battery can be charged ("Charge current limit") and discharged ("Discharge current limit"), as well as the maximum regeneration current value with which the modular battery can be charged during operation under load ("Regeneration current limit"). The calculation of the discharge current and regeneration current of the entire battery is performed based on the number of battery modules operating for discharge and the maximum discharge and charge current values ​​transmitted by them.
299 +In addition to controlling the charge/discharge contactor, the charge/discharge controller calculates and transmits to the upper-level system the maximum allowable current value with which the modular battery can be charged ("Charge current limit") and discharged ("Discharge current limit"), as well as the maximum regeneration current value with which the modular battery can be charged during operation under load ("Regeneration current limit"). The calculation of the charge, discharge current and regeneration current of the entire battery is performed based on the number of battery modules operating for discharge and the maximum discharge and charge current values ​​transmitted by them.
300 300  
301 -"Charge current limit" calculated only if Charge r
301 +* "Charge current limit" and "Regeneration current limit" are calculated only if there is "Charge request".
302 +* "Discharge current limit" is calculated only if there is "Discharge request".
302 302  
303 303  The charge/discharge contactor control is configured in the “Control → Charge/Discharge” section:
304 304