Skip to Content

Changes for page 6.2 Modbus protocol

Last modified by Admin on 2025/03/20 12:12
From version 12.1
edited by Admin
on 2025/02/04 10:35
Change comment: There is no comment for this version
To version 6.1
edited by Admin
on 2025/02/04 09:39
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -227,7 +227,9 @@
227 227  
228 228  bit 26 — signal “External 1”;
229 229  
230 -bits 27-31 — not used.
230 +bit 27 — signal “Heater (AUX)”;
231 +
232 +bits 26-31 — not used.
231 231  )))|(% style="width:37px" %)U32
232 232  |(% style="width:73px" %)**0x200B**|(% style="width:66px" %)1|(% style="width:437px" %)(((
233 233  Discrete output signals (bitfield):
... ... @@ -300,9 +300,7 @@
300 300  
301 301  bit 18 — “Power fault”;
302 302  
303 -bit 19 — “Current limit" error;
304 -
305 -bits 20-31 — not used.
305 +bits 19-31 — not used.
306 306  )))|(% style="width:37px" %)U32
307 307  |(% style="width:73px" %)**0x2010**|(% style="width:66px" %)1|(% style="width:437px" %)Address of the BMS Logic device the parameters of which are in registers 0x2011-0x20C9|(% style="width:37px" %)U16
308 308  |(% style="width:73px" %)**0x2011**|(% style="width:66px" %)1|(% style="width:437px" %)(((
... ... @@ -649,14 +649,5 @@
649 649  
650 650  2-65535 – use the physical input "Close Main contactor".
651 651  )))
652 -|(% style="width:71px" %)**0x5115**|(% style="width:75px" %)1|(% style="width:469px" %)(((
653 -Software control of the "Close External 1" signal. Allowable values:
654 654  
655 -0 – clear the signal;
656 -
657 -1 – set the signal;
658 -
659 -2-65535 – use the physical input "Close External 1".
660 -)))
661 -
662 662