Skip to Content

Changes for page 3.3 Control

Last modified by Admin on 2026/04/30 15:56
From version 94.1
edited by Admin
on 2026/04/30 15:56
Change comment: There is no comment for this version
To version 92.1
edited by Admin
on 2026/04/30 13:56
Change comment: Загрузить новое вложение 1777557391157-274.png

Summary

Details

Page properties
Content
... ... @@ -489,7 +489,7 @@
489 489  * **Errors 1, 2 to open the charging contactor** – bitfields to choose the errors which will open the charging contactor;
490 490  * **Use custom delays before stopping charging (on errors)** – a flag to enable manual settings of time delays T,,off,, for specific errors;
491 491  * **Custom delay: <error>** – delay for specific error, millisecond;
492 -* **Switch off the charging contactor on errors without delay** – a flag to protectively open the charging contactor without a delay. In the opposite case, when an error is detected, the charging contactor opens always with the delay “Delay before stopping charging”.
492 +* **Switch off the charging contactor on errors without delay** – a flag to protectively open the charging contactor without a delay. In the opposite case, when an error is detected, the charging contactor opens always with the delay “Delay before stopping charging”;
493 493  
494 494  === Discharge ===
495 495  
... ... @@ -707,7 +707,7 @@
707 707  * the battery voltage is below the minimum level;
708 708  * the “Charger connected” signal is cleared for 60 seconds.
709 709  
710 -The BMS Main 3 / BMS Main 2R device also shuts down the battery if it **stays for a long time **in the “Charging OFF”, “Discharging OFF”, “Relaxed (after charging)” or “Relaxed (after discharging)” state.
710 +The BMS Main 3 device also shuts down the battery if it **stays for a long time **in the “Charging OFF”, “Discharging OFF”, “Relaxed (after charging)” or “Relaxed (after discharging)” state.
711 711  
712 712  To change the parameters of the power down control, select the "Control → Power down" section:
713 713