Changes for page 3.3 Control

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -464,11 +464,11 @@
464	464	When the "**On charge request**" algorithm selected, the control is performed as follows:
465	465
466	466	* If there is a signal “Charge request” and there are no errors (see the "Errors 1, 2 ..." bitfields), then through the delay time T,,on,, the "Charging" and the "Allow charging" signal are set;
467		-* If the signal “Charge request” disappears or errors occur (see the "Errors 1, 2 ..." bitfields), the allow charging contactor opens and after the delay time T,,off,, the charging contactor opens;
	467	+* If the signal “Charge request” disappears or errors occur (see the "Errors 1, 2 ..." bitfields), the "Allow charging" signal is cleared and after the delay time T,,off,, the "Charging" signal is cleared;
468	468
469	469	(% class="box infomessage" %)
470	470	(((
471		-**Note: **when errors occur in the system, the **Charge **contactor opens either immediately or with the delay T,,off,, (depends on the settings described below).
	471	+**Note: **when errors occur in the system, the **"Charing" **signal is cleared either immediately or with the delay T,,off,, (depends on the settings described below).
472	472	)))
473	473
474	474	To change the parameters of the battery charge control algorithm, select the "Control → Charge" section:
...	...	@@ -493,7 +493,7 @@
493	493
494	494	=== Discharge ===
495	495
496		-The BMS Main 3 / BMS Main 2R device controls the discharging contactor to connect battery to the load.
	496	+The BMS Main 3 / BMS Main 2R device controls the discharging contactor to connect battery to the load by the "Discharging" signal.
497	497
498	498	BMS Main 3 / BMS Main 2R supports three algorithms to control battery discharging:
499	499