Changes for page 3.3 Control

Last modified by Admin on 2026/04/30 15:56

From version 87.10

edited by Admin
on 2026/04/02 10:30

Change comment: There is no comment for this version

To version 87.14

edited by Admin
on 2026/04/02 10:38

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -542,16 +542,16 @@
  === Charge/Discharge ===
--The BMS Main 3 / BMS Main 2R device can control the contactor used in power line both used forasdf charging and
++The BMS Main 3 / BMS Main 2R device can control the contactor, used in power line both used for connecting battery to charger and load, by using the "Charging/Discharging" signal.
--Charge/Discharge contactor has three algorithms of operation:
++"Charging/Discharging" signal has three algorithms of operation:
--On **Dependent (on Charging and Discharging signals)** algorithm the charge/discharge contactor depends on Charge and Discharge controllers and behaves:
++On **Dependent (on Charging and Discharging signals)** algorithm the "Charging/Discharging" signal depends on Charge and Discharge controllers and equal to:
--* as Charging contactor if "Charging" signal is set;
--* as Discharging contactor in other cases.
++* "Charging" signal if "Charging" signal is set;
++* "Discharging" signal in other cases.
--When **Independent (Always) **algorithm is selected, the charging/discharging contactor is always closed. If at least one of the errors from the "Errors 1, 2 ..." bitfields appears or one of the signals:
++When **Independent (Always) **algorithm is selected, the Charging/discharging contactor is always closed. If at least one of the errors from the "Errors 1, 2 ..." bitfields appears or one of the signals:
  * Service reset
  * Power down request