Skip to Content

Changes for page 3.3 Control

Last modified by Admin on 2026/04/30 15:56
From version 78.4
edited by Admin
on 2026/03/31 14:28
Change comment: There is no comment for this version
To version 80.2
edited by Admin
on 2026/03/31 14:32
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -626,9 +626,9 @@
626 626  
627 627  The following **balancing rules** are supported:
628 628  
629 -* when the battery is charging (current I > 0) and time after until the battery is relaxed;
630 -* when the battery is charging (current I > 0) or when the battery is in a state of relaxation;
631 -* always (regardless of battery state).
629 +* **Balance on charge** – perform balancing when the battery is charging (current I > 0) and time after until the battery is relaxed;
630 +* **Balance on charge or relaxed** – perform balancing when the battery is charging (current I > 0) or when the battery is in a state of relaxation ​​​​​;
631 +* **always** (regardless of battery state).
632 632  
633 633  A balancing resistor is connected to the cell if the following conditions are simultaneously met:
634 634  
... ... @@ -787,7 +787,7 @@
787 787  
788 788  === High voltage ===
789 789  
790 -(% class="box infomessage" %)
790 +(% class="box warningmessage" %)
791 791  (((
792 792  This section is not available on BMS Main 2R.
793 793  )))
... ... @@ -834,10 +834,8 @@
834 834  * **Logic index, Cell index** – a position of the analyzed cell;
835 835  * **Analyse the most discharged cell** – a flag to analyse of the least charged cell (in this case, the values “Logic index” and “Cell index” are ignored).
836 836  
837 -Discharge step should be set equal to С/21,
837 +Discharge step should be set equal to С/21, where C is the cell capacity.
838 838  
839 -where C is the cell capacity.
840 -
841 841  The discharge characteristic will be constructed for the given cell (its position is determined by the fields “Logic index” and “Cell index”).
842 842  
843 843  The algorithm for determining the discharge characteristic of the battery will be started if the “Enable” flag is set. From this moment, the control of the discharge contactor is performed by this algorithm.