Skip to Content

Changes for page 3.3 Control

Last modified by Admin on 2026/04/30 15:56
From version 78.3
edited by Admin
on 2026/03/31 14:27
Change comment: There is no comment for this version
To version 78.2
edited by Admin
on 2026/03/31 14:26
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -761,12 +761,12 @@
761 761  
762 762  In this section:
763 763  
764 -* **Enable** – a flag to enable the cooler control;
765 -* **Maximum cell temperature**, °C;
766 -* **Tolerant cell temperature**, °C;
767 -* **Delay before starting the cooler**, millisecond;
768 -* **Delay before stopping the cooler**, millisecond;
769 -* **Errors 1, 2 to open the cooler **– bitfields to choose the errors which will open the cooler.
764 +* Enable – a flag to enable the cooler control;
765 +* Maximum cell temperature, °C;
766 +* Tolerant cell temperature, °C;
767 +* Delay before starting the cooler, millisecond;
768 +* Delay before stopping the cooler, millisecond;
769 +* **Errors 1, 2 to open the heater** – bitfields to choose the errors which will open the heater.
770 770  
771 771  As a result of operating the cooling algorithm, the "Cooler" signal is generated.
772 772  
... ... @@ -787,7 +787,6 @@
787 787  
788 788  === High voltage ===
789 789  
790 -
791 791  The BMS Main 3 device has an ability to measure high voltages before and after contactors.
792 792  
793 793  To change the parameters of high voltage fault, select the "Control → High voltage" section: