Skip to Content

Changes for page 3.3 Control

Last modified by Admin on 2026/04/30 15:56
From version 76.3
edited by Admin
on 2026/03/31 12:29
Change comment: There is no comment for this version
To version 76.4
edited by Admin
on 2026/03/31 12:36
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -22,9 +22,9 @@
22 22  * **Parallel-Serial: Number of serial blocks in a string**;
23 23  * **Relax time (after charging)** – a relaxation time after charging, second;
24 24  * **Relax time (atfer discharging)** – a relaxation time after discharging, second;
25 -* **Reset SOC** – a command to reset cells state of charge;
26 -* **Reset resistance** – a command to reset cells resistance;
27 -* **Reset capacity** – a command to reset cells capacity;
25 +* **Reset SOC** – a command to reset cells state of charge. New cell SOC values will be calculated based on cell voltage and “Uocv (open-circuit voltage) table”: in the “Control → SOC estimation” section;
26 +* **Reset resistance** – a command to reset cells resistance to “Cell resistance” value;
27 +* **Reset capacity** – a command to reset cells capacity to “Cell capacity” value;
28 28  * **Method of calculating the battery voltage***:
29 29  ** **Summation of cell voltages** – the overall voltage is calculated as on sum of all cells in the battery;
30 30  ** **Using voltage before contactors** – the overall voltage is estimated as voltage before contactors measured by BMS.
... ... @@ -35,14 +35,8 @@
35 35  
36 36  The values of **“Relax time”** are used to determine the state of the battery. If the battery is in a state of relaxation, the system recalculates the voltage on the cells to the state of charge of the battery.
37 37  
38 -The** “Reset parameters”** will reset:
38 +The **“Reset ”** command is used for starting-up and adjustment of the battery.
39 39  
40 -* state of charge (new cell SOC values will be calculated based on cell voltage and “Uocv (open-circuit voltage) table”: in the “Control → SOC estimation” section);
41 -* cell resistance to “Cell resistance” value;
42 -* battery capacity to “Cell capacity” value.
43 -
44 -The **“Reset parameters”** command is used for starting-up and adjustment of the battery.
45 -
46 46  === SOC estimation ===
47 47  
48 48  The BMS Main 3 device calculates the state of charge of the battery (SOC) using two algorithms: